E. coli in Your Water Test: What to Do
Drinking water should have no E. coli, and any "present" or count above zero means human or animal waste is getting into your water (EPA). Today, boil water for one minute, or use bottled water, for drinking, cooking, washing produce, brushing teeth, ice, and baby formula; you can still bathe, but keep children from swallowing the water.2
This week, call your county health department, look for a septic problem or animal waste near the well, have the well disinfected, and retest. If E. coli comes back, a well repair or a disinfection system for all the water in the house is the fix.
Why it matters
"A positive E. coli result is much more serious than coliform bacteria alone because it indicates that human or animal waste is entering the water supply."1 EPA says the germs in that waste "can cause diarrhea, cramps, nausea, headaches, or other symptoms" and "may pose a special health risk for infants, young children, and people with severely compromised immune systems" (EPA). If someone in the house is sick, call a doctor and mention the test.
Today
- "Boil for one minute all water to be used for drinking, cooking, washing fruits and vegetables, brushing teeth, and making ice cubes, baby formula and concentrated juices."2
- "Use for bathing, but make sure children do not drink water by sucking on washcloths or sponges."2
- "If nitrate or arsenic were also detected in your well water, boiling your water may not be the safest option."3 Use bottled water if your report shows either one.
Common results
| Result | What it means |
|---|---|
| E. coli absent | No E. coli found. If total coliform on the same report was present, read the coliform page. |
| E. coli present | Human or animal waste is reaching the water. Boil or buy all drinking and cooking water now. |
| <1 MPN per 100 mL | MPN, most probable number, is an estimated count. Less than 1 means none found, the same as absent.1 |
| 4 MPN per 100 mL | E. coli found. Drinking water should have none, so any count above zero means following the steps on this page.1 |
| Fecal coliform present | Some labs test fecal coliform instead. It is the same kind of warning, so take the same steps. |
Example results. EPA groups fecal coliform and E. coli together as signs of waste (EPA).
This week
- Find the source. "If E. coli bacteria are present, check your septic system for proper functioning and remove or divert obvious sources of animal waste from around the well or spring."1
- Fix and disinfect. New Jersey says a single E. coli positive is reason to find and correct the source, which can mean a well repair, or to install treatment, and that a well professional may be needed.4 Shock chlorination comes after repairs. Well after a flood has EPA's bleach steps.
- Retest. Penn State says to retest 10 to 14 days after disinfecting, then again two to three months later.5 "You can use the water again, without boiling, once the well has been disinfected and the water no longer tests positive for coliform bacteria."3
If it comes back
Penn State found shock chlorination worked best in wells with few coliform bacteria and no E. coli.5 If E. coli comes back, the choices are a well repair or a new well, or a disinfection system that treats all water entering the house: chlorination, ultraviolet (UV) light, or ozone.4 "However, UV light units are not recommended for water supplies where total coliform bacteria exceed 1,000 colonies per 100 mL or fecal coliform bacteria exceed 100 colonies per 100 mL."1
Total coliform on the same report? The coliform page reads those counts.
New to lab reports? How to read a water test report. Another number on your report? Check it in the results checker.
Sources
- Penn State Extension, Coliform Bacteria
- Vermont Department of Health, Coliform Bacteria in Drinking Water
- Minnesota Department of Health, Bacterial Safety of Well Water
- New Jersey Department of Health, Total Coliform and E. coli in Private Well Drinking Water
- Penn State Extension, Shock Chlorination of Wells and Springs
Checked November 15, 2026.
